This method should only be used when all previous ones (Factory Reset & Soft Recovery) have failed because it causes them to write in the EMMC Flash and can damage the equipment if something goes wrong.
What you will need:
- A recovery image,
- Amlogic USB Burning Tool,
- Install the drivers that have inside the WorldCup_Device folder, are inside folder that previously downloaded the Amlogic USB Burning Tool,
- Cable micro usb smartphones (musb) - (Photo attached 1:),
- Membrane musb (Femea Micro usb - USB Male) - (Photo attached 2:).
1 -
2 -
Procedure:
- Disconnect the equipment from the chain and remove all cables from the same,
- Connect the cables / adapter musb to box, but not yet to the pc,
- Open the Amlogic USB Burning Tool program,
- Change the language to English of the program as shown in the image below,
- With something thin hold down the recovery button (in the back of the box),
- Connect the musb cable to the pc and if all went well you will soon see Connected Success if you do not have to check if you have installed the WorldCup_Device drivers as described above,
- Drop the recovery button,
- Click on import image and choose the recovery image .iso,
- Make sure you have the visas in Erase Flash, Erase Bootloader,
- Click Start,
- The entire process can take up to 5 minutes.
Hi!
ReplyDeleteI am trying to recover my device, but Amlogic USB Burning Tool linked above is not the tool which is described in the 3rd method.
Thank you for help in advance.
pozdrav, jeste li uspjeli??
Delete